Solo Hitch

How to Set Up and Use

Intial Setup

1. Reverse your vehicle towbar directly under the accomodating hitch of your trailer or caravan.

2. Remove Solo Hitch from Packaging.

3. The solo Hitch consists of 3 main components,

A. Main Frame

B. Wheel Stop

C. Hitch Post

4. Remove the four finger bolts and lift off the hitch post.

5. Slide out the wheel stop.

6. Open the main frame and screw the support brace, with the finger bolt, into the hole nearest the hinge.

7. Line the longest leg of the Solo Hitch main frame up against the back drivers side tyre. Note : Ensure this leg of the main frame runs in line with the car. At the same time it is importants that the short leg of the main frame is roughly in line with the hitch of your caravan or trailer.

8. Place the hitch post onto the short leg with finger bolts facing inwards, slide the post up until it touches the side of the hitch. Tighten the bolts.

9. You can now place the wheel stop onto the long leg of the frame up to the back of the tyre.

10. Mark the locations of the hitch post and wheel stop with the arrow stickers provided.

11. Your positions are now set, the Solo Hitch can now be folded away.

 

 

General Use

1. Open the Solo Hitch as described previously

2. Place the hitch post and wheel stop on pre-marked positions, ensuring hitch post is screwed on.

3. Line up hitch post with centre-line of hitch.

4. You can now reverse up the inside of the long leg of the Solo Hitch until you gently touch the wheel stop.

5. You can now drop your hitch onto the towball.